posted by dman on Sep 4
If you are are looking for or have recently got your new reel you will no doubt be wanting to test it out.
Fishing reels and especially baitcasters have gained much popularity recently despite being thought of harder to cast of, which is due to how fast the line is released compared to other makes of reel, such as spincasters.
Knowing how to spool your line onto a baitcaster reel though might be an altogether new challenge for you.
Spooling a baitcaster is certainly a know how you will need as you may need to do this when you first get your fishing reel and of course you are more than likely to be in a situation where you need to do this on a fishing outing. However, it isn’t too difficult if you read these simple steps below.
To start with, you have to get some suitable fishing line to spool. The type is up to you and more importantly what you are fishing although in most cases 10lb test line should be strong enough. Of course, if you are after bigger fish then be certain to use a stronger line or you may be left with no fish and no line left either!
Although its a bit hard to get this done when on a fishing trip, a simple trick to make it simpler is to soak the line first in hot water for about 30 minutes and it helps to stop the line tangling so much as the curl will be a lot looser. This is worth trying if you experience any problems doing it, but make sure to let it dry first.
Push the free end of the fishing line through the fishing rod guides that you can see on the rod – these appear to be small metal circles. Start at the tip where the guide should be smaller than the others. You should notice they are bigger at the other end. Keep on threading through the guides until you reach the reel end of the rod.
When complete, wrap the line around the spool a single time and tie a knot in it. This will be used to start getting the line onto the spool. Put the new fishing line on the floor as you wont need to hold it now. In a standing position place the tip of the rod so it is close the the new line which is on the floor – This means the rod is now facing the ground. Try to close the gap between the new line and rod tip as much as possible.
Turn the fishing reel handle so it loads the new fishing line onto the reel spool and keep going until it is full. When you are done, simply cut the line at the rod tip and you’ve now spooled a baitcaisting reel.









